LLM Agent-Based Design of RISC-V CPUs with FPGA-in-the-Loop Evaluation

概要

Long-run RTL simulation of CPU candidates can take hours, while short diagnostic runs may miss performance degradation that emerges later in execution. This evaluation cost can delay design decisions in LLM-agent-based CPU development. We present a development environment in which LLM agents implement CPU candidates on an FPGA and use on-board performance measurements to guide design decisions. We applied it to the human-supervised development of a single-cycle RV32I core into a three-wide out-of-order RV32IM core. The final design reaches 5.61 CoreMark/MHz at 130 MHz on a Artix-7 FPGA. For the same CPU candidate running 8,000 CoreMark iterations, FPGA evaluation, including implementation, was 9.6x faster than single-threaded RTL simulation. In one case, board measurements revealed long-run performance degradation in a candidate that improved in a short diagnostic run. The result guided candidate selection and led to RTL-based root-cause analysis and a fix.

参考リンク

• Paper ↗

リンク先のライセンス・再現性・データ条件をご確認ください。自動分類や実装の目安は保証ではありません。

実装を始めるプロンプト

参考リンクを確認したうえで、次の内容をコピーして利用できます。

# 論文・記事
LLM Agent-Based Design of RISC-V CPUs with FPGA-in-the-Loop Evaluation

# 概要
Long-run RTL simulation of CPU candidates can take hours, while short diagnostic runs may miss performance degradation that emerges later in execution. This evaluation cost can delay design decisions…

# 原典
https://arxiv.org/abs/2610.39570

上記の手法を実装してください。実行前に依存関係とライセンスを確認してください。